Step 1 - Cut a hole in the PondGard panel that is approximately 75%
the outside diameter of the pipe protruding from the substrate.
Step 2 -
Slide the PondGard into place over the base of the pipe.
(Steps 3 & 4 Continued Below)
In the event you can not move the PondGard panel
Sub Step 1 -
Cut the panel to expose the pipe.
Sub Step 2 - Cut a target patch with a properly sized hole and
place it over the pipe.
Sub Step 3 - Ensure the liner is dry and free of mud or other
contaminants.
Sub Step 4 - Seam the target patch to the PondGard panel with
primer and either 6” QuickSeam Cover Strip or QuickSeam Splice
Tape (See either Detail 9- Creating A Seam With 6" QuickSeam
Cover Strip Tape or Detail 10- Creating A Seam With 3"
QuickSeam Splice Tape).
Step 3 - Once the PondGard is properly positioned over the pipe adhere
a piece of QuickSeam FormFlash to the pipe.
Step 4 - Roll the flashing to insure adhesion to the pipe.
This Detail featured these Firestone Specialty Products:
• PondGard EPDM Rubber Membrane
• QuickPrime Plus Primer
• QuickScrubber
• Hand roller